Services
Products
Videos



Producing electricity from the heat of the flue gas plant

  03/10/2015

Producing electricity from the heat of the flue gas plant


The system uses steam propane (propane) are converting waste heat from industrial chimneys of power has been the American scientists fabricated. Not only created a significant power source, this system also helps reduce carbon dioxide and other pollutants from factory chimneys into the atmosphere.

Advantages of the system Vietnam in that it uses propane vapor instead of steam to drive turbines and generators running. This allows the system to normal operation, even with the flow of low temperature waste heat.

The steam used to drive the generator must be compressed and heated to a temperature of about 650oC. If for any reason, the temperature was lowered to below 450oC, the generator will operate inefficient because water pressure is weak. Thus, in the flue gases have a lower temperature to 450oC can not run the generator and will be dispersed into the air. This is one reason why the power plants use oil or coal generally has a total actual performance is only around 35%. Many industrial manufacturing processes, such as chemical plants or oil filter often to waste a considerable heat source.

Unlike steam, propane have properties more suitable for applications to run generators at low temperatures. After being compressed into liquid form prppane lower boiling point, so it can evaporate at a lower temperature than water. However, when propane, passed the turbine remains a useful amount of heat is relatively large. If you do not take advantage of this heat, it's a huge waste. Moreover, if only to stop here, the generator performance increase using propane still not commensurate with the investment costs have to spend to replace water by propane.

A simple solution to staggering levels by Daniel Stinger, and Farouk Mian turbine engineer, petroleum engineer who the US has just announced will solve this problem. To fully exploit the waste heat for electricity production, they have to install an extra second turbine. This turbine will be powered by waste heat from the first turbine and can absorb most of the remaining heat. According to calculations, the temperature of the fumes from the chimney after going through both turbines to about 55 ° C.

According to estimates, if that turns 20% of industrial waste heat into electricity, the United States, countries wishing to use the world's largest energy, will have an additional 20% of electricity demand necessary.

Stinger and Mian's solution will enable the manufacturing industry to fully utilize the waste heat from the chimney power plants have lower temperature 450oC. Type for the bulk of the waste heat in the area. The power plant uses such dual turbine system can increase efficiency from 35% to 60% potential. The remarkable result of this has made the idea of ​​the group is very much Stinger industry heavyweights such as BP and Chevron Texaco concern.

In fact, the production of electricity by the turbine, forcing use of propane will not give a cheaper source of electrical energy. Cost per megawatt of electricity produced by this method can equal one megawatt of electricity produced by conventional methods using water power. However, substantial benefits can not be denied is that the more conditions from the flue gas produced by the less CO2 will be released into the atmosphere.

But not the competent authority to verify the accreditation, but the Stinger and Mian technology, known under the name The cycle closed stratification (CCLC) has received many positive comments from the professionals. CCLC also has a strong potential: for exhaust after leaving the system was cooled to 55 ° C so a lot of the contaminants is still discharged directly into the air as mercury oxide, cadmium oxide will be condense in the chimney and then will be collected safely by the chemical treatment.

(Source: Website Vietnam Industry)